JIS G3456 Carbon steel pipes for high temperature service
JIS G3456 Carbon steel pipes for high temperature service.
This Standard specifies the carbon steel pipes (hereafter referred to as “pipes”, mainly used for piping at a temperature over350℃.
Remarks 1 When previously agreed upon by the manufacturer, the purchaser may designate one or all of the supplementary quality requirements 1 Yield point or proof stress in elevated temperature test (Z2), 2 Ultrasonic examination, (23) or 3Eddy current examination (24) Specified in annex 1 (normative) in addition to the items specified in this text.
2 The International Standard corresponding to this Standard is as follows.
In addition, symbols which denote the degree of correspondence in the contents between the relevant International Standard and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/IEC Guide 21.
IS0 9329-2 : 1997 Seamless steel tubes for pressure purposes-Technical delivery conditions-Part 2 : Unalloyed and alloyed steels with specified elevated temperature properties (MOD)
IS0 9330-2 : 1997 Welded steel tubes for pressure purposes-Technical delivery conditions-Part 2 : Electric resistance and induction welded unalloyed and alloyed steel tubes with specified elevated temperature properties (MOD)
2 Normative references
The standards listed in attached table 1 contain provisions which, through reference in this Standard, constitute provisions of this Standard.
The most recent editions of the standards (including amendments) shall be applied.
Research use only,Commercial use is prohibited.
If you want to use it ,you can buy from following link: